Submersible pressure transmitter DV403

• Hydrostatic level measurement
• Outside diameter: 23 mm.
• Measuring sensor: ceramic
• Cable with steel port and compensation tube

Description

This series of submersible pressure transmitters, made of polypropylene of 40 mm. in diameter they are suitable for continuous measurement of hydrostatic level and are designed to withstand immersion in aggressive fluids, even marine.
Submersible level probe has a wide range of fixed measuring ranges from 0 250 mbar to 0 … 10 bar (on demand is supplied with the appropriate range for each installation).

GENERAL CHARACTERISTICS
• Ceramic sensor with high precision and long-term stability
• Resistance to climatic changes due to its encapsulated electronics and a system of
pressure compensation
•  Output signal: 4 ÷ 20 mAdc.
• It is supplied as standard with 10 meters. of cable mod. CS-700 or CS-800 (on request it is supplied with additional lengths suitable for each installation)
• The cable mod. CS-700 or CS-800 that is part of the meter set has a double sealing chamber with a reference tube to balance the outside atmospheric pressure and a braided steel cable that acts as a guard against tensile stresses

•Protection against voltage overloads
• Repairable level probes

Technique used
The measurement sensor of the submersible pressure transmitter is made of ceramic, the piezoresistive technique being used.
This technology is related to the deformation of the ceramic membrane of the sensor, in which four electrical resistances are recorded forming a Wheatstone bridge. Therefore, any deformation caused by the effect of a pressure will unbalance the electronic circuit that will form a linear and proportional output signal to the pressure supported by the ceramic cell. The ceramic sensors used are compensated internally in temperature by means of PTC resistors.
The use of ceramic technology, in the field of pressure transmitters, provides excellent reliability when the pressure is made directly on the diaphragm of the ceramic sensor. Since there is no fluid chamber in its interior (synthetic oil, glycerin, etc., which can produce variations due to expansion effects) it provides a high stability against the effects of temperature.
The effects of atmospheric pressure on the liquid surface are transmitted through the pressure compensation tube to the upper part of the ceramic diaphragm and compensated.

Characteristics

This series of submersible pressure transmitters, made of polypropylene of 40 mm. in diameter they are suitable for continuous measurement of hydrostatic level and are designed to withstand immersion in aggressive fluids, even marine.
Submersible level probe has a wide range of fixed measuring ranges from 0 250 mbar to 0 … 10 bar (on demand is supplied with the appropriate range for each installation).